Blueboard-LPC1768-S

Blueboard-LPC1768-S

BlueBoard-LPC1768-S is a stamp board for NGXâ€â„¢s Blueboard Base. The LPC1768 microcontroller has 512KB of internal flash and 64KB RAM. Ethernet MAC, USB Device/Host/OTG interface, 8-channel general purpose DMA controller, 4 UARTs, 2 CAN channels, 2 SSP controllers, SPI interface, 3 I2C-bus interfaces, 2-input plus 2-output I2S-bus interface, 8-channel 12-bit ADC, 10-bit DAC, motor control PWM, Quadrature Encoder interface, 4 general purpose timers, 6-output general purpose PWM, ultra-low power Real-Time Clock (RTC) with separate battery supply, and up to 70 general purpose I/O pins

Following are the salient features of the board.

• Dimensions: 47x47 mm2
• Two layer PCB (FR-4 material)
• 32Khz crystal for RTC
• 12MHz crystal
• Test LED

Schematics
User Manual
Source Code


What tools to use?
Our products are in general not tied up to one particular tool. All the tools that support lpc1700 cortex-M3 series of micro controllers can be used, to name a few:

• KEIL uvision4 IDE a 32K code limited version could be used
• Rowley Crossworks comes with 30 day evaluation version
• IAR workbench a 32K code limited version could be used
• And off course GCC based open source tool chains
• For those who wish to program (hex files) usingparallel port programmer could consider H-JTAG
  

How to program the board?
There are various options:

• JTAG interface: one could use eitherparallel port programmer orNGX ARM USB JTAG
• ISP programming: Programming through the on chip boot loader using UART interface and Flash Magic
• USB secondary bootloader